/interface
/ethernet
set [ find default-name=ether1 ] bandwidth=10M/10M
Was this post helpful?
Let us know if you liked the post. That’s the only way we can improve.
Total Page Visits: 2457 - Today Page Visits: 3
You may also like
I eventually solved this problem. Edit /etc/rc.d/rc.firewall.up After the section on “# Allow packets that we know about through …” Add: # […]
The below will open tcp port 10000 on FirewallD to get access to webmin firewall-cmd –permanent –zone=public –add-port=10000/tcp A reload of FirwwallD […]
How to set the NTP client on a Mikrotik router using the Terminal /system ntp client set enabled=yes primary-ntp=###.###.###.### secondary-ntp=###.###.###.### Change the […]
This is the command to remove a folder/directory including its contents, use with caution as you wont get an “are you sure” […]